Product Description Water Standpipe Complete The Water standpipe will connect onto 20mm, 25mm, 32mm MDPE pipe and include a double check valve. Comes with: 1 x 20mm, 25mm, OR 32mm -3/4″ Female Elbow Compression Fitting 1 x 1mts x 3/4″ Galvanised Tube 1 x Double Check Valve 1 x Galvanised Male-Female Elbow (+ Galv reducing Bush on 1/2″ Tap Model) 1 x 1/2″(3/4″ outlet – suitable for Tap Timers etc) or 3/4″(with 7/8″ Outlet – Geka Fitting Included) Single Bib Tap 3 x 25mm pipe clamps 1 x PTFE Tape Self Assembly required Instructions *Note – Use the provided PTFE tape to seal threaded connections* Attach inlet elbow to the bottom of the galvanised tube Then attach the DZR check valve to the top of the tube, ensuring the arrow points in the right direction(direction of the flow, which in this case the arrow should be pointing up) Then attach the male/female galvanised elbow, (adding the galvanised reducing bush to the female outlet if using the 1/2″ Tap) Attach The tap. Use extra ptfe where required to position the tap correctly. Install pipe clips to the surface you are mounting to – for these you will need to provide your own screws/rawlplugs depending on the material you are mounting to.